- Turn on your TV.
- Turn on your FibreOP TV receiver.
- Point your FibreOP TV remote at the receiver.
-
Press the STB button on your FibreOP TV remote.
-
Press and hold the SETUP button until the STB button blinks twice.
-
Press the TV button.
-
Press and hold the OK button until your TV turns off.
-
If your TV has not turned off:
- Test whether programming was successful by pressing the POWER button on your FibreOP TV remote, and
- If your TV does not turn off, try programming your remote with the direct-code-entry method or popular-brand method.
- If your TV does not turn off, try programming your remote with the direct-code-entry method or popular-brand method.
- From the list below, indentify and make note of the 1-digit code for your TV brand. If your brand is not listed, try programming your remote with the code-search method or direct-code-entry method.
TV brand 1-digit code Insignia / Dynex 1 LG / Zenith 2 Mitsubishi 3 Panasonic 4 Phillips / Magnavox 5 Samsung 6 Sharp 7 Sony 8 Toshiba 9 Vizio 0 - Turn on your TV.
- Turn on your FibreOP TV receiver.
- Point your FibreOP TV remote at the receiver.
-
Press the STB button on your FibreOP TV remote.
-
Press and hold the SETUP button until the STB button blinks twice.
-
Press the TV button.
-
Use the remote's number pad to enter the 1-digit code that you previously identified and noted.
-
If programming is successful, your TV turns off and the TV button blinks twice.
-
If your TV has not turned off:
- Test whether programming was successful by pressing the POWER button on your FibreOP TV remote, and
- If your TV does not turn off, try programming your remote with the direct-code-entry method or popular-brand method.
- If your TV does not turn off, try programming your remote with the code-search method or direct-code-entry method.
- Identify and make a note of the 4-digit code(s) for your TV brand from the Nova remote's 4-digit code list .
If your brand is not listed, try programming your remote with the popular-brand method.
- Turn on your TV.
- Turn on your FibreOP TV receiver.
- Point your FibreOP TV remote at the receiver.
-
Press the TV button on the remote.
-
Press and hold the SETUP button until the TV button blinks twice.
-
Use the remote's number pad to enter the first 4-digit code that you previously located and noted for your TV brand.
-
Press the POWER button on your remote.
- If programming is successful, your TV and receiver turn off.
- If your TV does not turn off, repeat steps 7 and 8 for each of the 4-digit codes listed for your TV brand.