To watch your TV, your TV must be set to the input source that was used to connect the FibreOP receiver. Change your input source by following the step-by-step instructions below.
Follow these easy steps
- With your TV remote (not the remote for your FibreOP receiver), enter 03.
- Press the Input button (this may also be labelled Source or TV/Video depending on your remote)
- Wait a few seconds to see if the channel appears
- If the channel does not appear, press the Input button again for the next input option presented on your TV. Wait a few seconds to see if the channel appears.
- Continue to repeat step 4 if the channel does not appear as you cycle through all of the input options on your TV.